Designing The Parts V – AT24C64

Designing The Parts V – AT24C64

Following the same way that we did with the previous articles, we now have to design the component AT24C64, which is an EEPROM memory. This time, I didn’t find any component like that on Sparkfun’s or Adafruit’s library. This time you really might need to draw the component!

Continue reading “Designing The Parts V – AT24C64”

Designing The Parts IV – PCF8563

Designing The Parts IV – PCF8563

Following the same way that we did with the previous articles, we now have to design the component PCF8563, which is a real-time clock module. This time, I didn’t find any component like that on Sparkfun’s or Adafruit’s library. This time you really might need to draw the component!

Continue reading “Designing The Parts IV – PCF8563”

Designing The Parts I – MPU6050

Designing The Parts I – MPU6050

After installing EAGLE from CadSoft, you may want to open some of the examples that come with the software. But, to begin our project, the user needs to have the components inside the library. You can use the Adafruit library, or you can make your own. If you don’t trust the library, you can always design your own part. Besides, even if you use the component from the library, you can always practice and learn.

Continue reading “Designing The Parts I – MPU6050”

IoT WiFi DIY motion detector with e-mail notification using PIR sensor and ESP8266

In this project I am using the ESP8266 WiFi module and PIR sensor motion detector to get e-mail alerts if someone enters the room while I am away. I am using GadgetKeeper Cloud Platform to bring e-mail notifications with PIR Sensor. I have choose GadgetKeeper Cloud Platform because it’s FREE and easy to use. The whole project costed me around $7 and was pretty easy to build.

Step 1: Parts

  • 1× esp8266-07 – Ebay;
  • 1× PIR Sensor – Ebay;
  • 1x Bread Board Power Supply – Ebay;
  • 1x 12V AC-DC Power Adaptor – Ebay;
  • 2x 400pin Breadboard – Ebay;
  • Wires.

Continue reading “IoT WiFi DIY motion detector with e-mail notification using PIR sensor and ESP8266”

Arduino Power-down Mode With Accelerometer, Compass and Pressure Sensor

Arduino Power-down Mode With Accelerometer, Compass and Pressure Sensor

Introduction

Last article, I wrote about how to use our own homemade Arduino Pro Mini bare bones along with an OLED display and how to make both of them consume as little power as possible. In fact, we managed to achieve a small 1.1 uA current with both of them sleeping. Also in our circuit there were a PCF8563 real-time clock module and one AT24C64 EEPROM memory. Now, to proceed with our smartwatch project we need to add sensors, such as an accelerometer, compass and pressure sensor. This article is about how to add them, read the variables and keep saving power.

Continue reading “Arduino Power-down Mode With Accelerometer, Compass and Pressure Sensor”