Arduino Power-down Mode With Accelerometer, Compass and Pressure Sensor

Arduino Power-down Mode With Accelerometer, Compass and Pressure Sensor

Introduction

Last article, I wrote about how to use our own homemade Arduino Pro Mini bare bones along with an OLED display and how to make both of them consume as little power as possible. In fact, we managed to achieve a small 1.1 uA current with both of them sleeping. Also in our circuit there were a PCF8563 real-time clock module and one AT24C64 EEPROM memory. Now, to proceed with our smartwatch project we need to add sensors, such as an accelerometer, compass and pressure sensor. This article is about how to add them, read the variables and keep saving power.

Continue reading “Arduino Power-down Mode With Accelerometer, Compass and Pressure Sensor”

OLED Display and Arduino With Power-Save Mode

OLED Display and Arduino With Power-Save Mode

On the previous article I wrote about how to use the real-time clock module with the EEPROM non-volatile memory. Now it is time to get something working that resembles a watch. Make something that matters. How about adding a display? Last post it was possible to achieve a power consumption of only 16 uA (improved) 0.7uA on the smartwatch prototype. Now we can see how much power the watch will consume. In this case, it is an application that needs to consume the smallest current possible but also needs a display, then one can use a OLED display, which is the abbreviation of “Organic Light-Emitting Diode”, which is a much more economic display in terms of current than the regular LED displays. An overview about OLEDs, first.

Continue reading “OLED Display and Arduino With Power-Save Mode”